Post by breckjensen on Nov 22, 2017 23:56:17 GMT -5
hello,
The following codes have been stored: po300, po430, po152.
I had the spark plugs changed, the EGR valve replaced, the o2 sensor replaced, and they smoked it for a vacuum leak, which they then repaired. After clearing all the codes and continuing to drive, the only code that comes back is PO300. The car has a rough idle and once in a while will violently shake when I come to a stop/red light, followed by the engine light flashing and then limp mode when I begin to drive.
I am absolutely lost... I have no idea what it could be at this point.
Anybody out there who can offer any suggestions at all, I thank you in advance.
Please help.
Thanks!
I didn't find the right solution from the Internet.
References:
www.300cforums.com/forums/general-discussion-issues-trouble-shooting/266098-new-300c-member-need-your-opinion.html
Motion Graphics Brand Video
The following codes have been stored: po300, po430, po152.
I had the spark plugs changed, the EGR valve replaced, the o2 sensor replaced, and they smoked it for a vacuum leak, which they then repaired. After clearing all the codes and continuing to drive, the only code that comes back is PO300. The car has a rough idle and once in a while will violently shake when I come to a stop/red light, followed by the engine light flashing and then limp mode when I begin to drive.
I am absolutely lost... I have no idea what it could be at this point.
Anybody out there who can offer any suggestions at all, I thank you in advance.
Please help.
Thanks!
I didn't find the right solution from the Internet.
References:
www.300cforums.com/forums/general-discussion-issues-trouble-shooting/266098-new-300c-member-need-your-opinion.html
Motion Graphics Brand Video